Climtec RD-100 Standard Recuperator
Climtec
7,480 ₴
1 / 2SKU РД-100СМ
Decentralized ventilation system with recuperator TM "CLIMTEC" - is a supply and exhaust ventilation system in which supply and extraction occur simultaneously and without mixing airflows.
A recuperator is a heat exchanger that in winter returns thermal energy escaping from the room with the exhaust air, and in summer prevents the penetration of heat with the supply air. The heat recovery process can save up to 75% of the heat lost during conventional room ventilation.


Unique airflow separation module. Indoor air is driven through the recuperator by one fan, and outdoor air by another. Airflows are separated in such a way that during fan operation they do not mix, but move in different channels of the heat exchanger in opposite directions.
Flow shut-off valve. The flow shut-off valve prevents wind blowing, drafts, and noise coming from the street. Its location in the rear (street) part of the recuperator makes freezing of the recuperator impossible at extremely low temperatures – when the recuperator is turned off, as the recuperator "pipe" remains "indoors".
Unique motor impeller shape. Due to the special shape of the 12-blade impeller, motor efficiency has increased by almost 2 times. Therefore, it was possible to reduce the power at which the motor operates, resulting in even greater energy resource savings and minimizing noise levels among analogs.
Cross-flow, counter-flow aluminum heat exchanger. Aluminum, from which the heat exchanger is made, does not oxidize, accordingly has no negative impact on the human respiratory system, allows working in a wide temperature range, has natural protection (oxide film) against corrosion, and prevents the development of fungal and putrefactive bacteria on the lamellas.
Air filter. The recuperator is equipped with "dust" and "carbon" filters that trap dust, exhaust gases, and unpleasant odors, making the air fresh and pleasant to breathe, and keeping rooms and furniture clean.
Temperature and CO2 sensor. The use of temperature and carbon dioxide sensors ensures a comfortable climate and air freshness precisely when needed, while maximizing energy resource savings.
Control: remote.
The recuperator has a single module completely ready for installation. The recuperator is mounted in the upper part of the wall bordering the street. To do this, it is necessary to make a through hole to the street of the appropriate diameter. Hole diameters vary depending on the model. The working module of the recuperator is installed in the wall hole using mounting foam or another sealant. Thus, the entire working module is located within the thickness of the wall, and only the ventilation grilles remain outside: one inside the room, the other on the facade. The through hole is made at an inclination of 3-5 degrees towards the street to allow condensate to drain from the heat exchanger. To ensure normal operation of the ventilation system, its air intake pipe (from the street side) must protrude from the wall by at least 5 mm.
Eco Dim company has the largest network of installation organizations for air recuperators in Ukraine: our representatives are located in all regional centers and large cities of Ukraine. Such a large network of installers allows us to install recuperators in almost any location in Ukraine. A detailed list of cities where installation is carried out can be seen here.
The list of recuperator installation works includes:
Pre-booking for installation is carried out when ordering the recuperator or separately with an Eco Dim company consultant by phone. Contact our sales consultant for all questions of interest: 0-800-331-765, 044-33-473-65, 098-61-555-15. We will perform the installation promptly, efficiently, and reliably.
To select a CLIMTEC recuperator model, two factors must be considered: room volume and the number of people permanently staying in the room. The air exchange rate for residential premises averages 30 m3/h per person. Having calculated the room volume and air exchange according to the number of people in the room, the larger of the two calculated values is selected.
Determination of the heat recovery efficiency coefficient (COP) is carried out by calculation using the formula:
Where
Kt - temperature recovery efficiency coefficient
T1 - outdoor air temperature, C
T2 - exhaust air temperature (room air), C
T3 - supply air temperature, C.
Dispatch to post branches, parcel lockers, or by courier to your doorstep. All packages are insured for 100% of value. Delivery time: 1–3 business days.
Flexible options: Cash on delivery at Nova Poshta branch or bank transfer invoice (IBAN) for individuals, FOP and companies.