DLM — Electronics, Tools & Home Store

Categories

Categories currently unavailable.

Open catalog
Language
UAEN
Flight stack for FPV quadcopter ARMADA F405 V1 65A AM32 3 -6S (set of controller and regulator)1 / 10
4 050 ₴
In Stock
1

Flight stack for FPV quadcopter ARMADA F405 V1 65A AM32 3 -6S (set of controller and regulator)

SKU ARMADA-F405V1-AM3265A

Description

Flight stack ARMADA F405 65A AM32 3-6S is a Ukrainian engineering flight controller and electronic speed controller kit for FPV quadcopters with frames from 4 to 10 inches up to 13 inches. The FPV stack combines a powerful flight controller based on the STM32F405 with high processing speed and a reliable 4-in-1 65A ESC running on open-source AM32 firmware for maximum efficiency and smoothness. The ARMADA stack is installed on FPV drones ranging from 4 inches to 10-13 inches, i.e., from FPV quadcopters to small tactical cargo drones, high-thrust quadcopters, and Long Range setups.

The FC F405 stack + 65A ESC 6S ARMADA is one of the most reliable stacks for FPV pilots who demand stability and performance. Currently in its niche, the ARMADA stack is one of the best F4-processor-based flight controller options in terms of price-to-quality ratio. The Ukrainian ARMADA F405 stack can more than confidently replace combined solutions from Chinese manufacturers such as Diatone, SpeedyBee, HobbyPorter, and others in quadcopter setups with propeller sizes from 4 to 10 inches. With a more powerful ESC included, the ARMADA stack is more affordable than Diatone.
The 10-inch quadcopter stack ARMADA is targeted at Ukrainian serial manufacturers of FPV drones who value operational predictability, a stable component base, parts availability, and quality technical support within Ukraine.

The controller circuitry is designed around the current generation low-noise ICM42688P accelerometer.

For configuration convenience, receiver power can be supplied via USB without a battery.
Built-in power filtering — less noise, stable sensor operation.
Reliable BEC for powering peripherals. The controller board features a separate BEC for powering the video transmitter with selectable voltage (5V, 9V, or 12V), which significantly improves video power quality and reduces electrical interference from motor operation.
Support for up to 3 servos allows simultaneous connection of an initiator and, for example, FPV camera tilt control.

Using two separate PinIO outputs, you can manage the power supply of the video transmitter and other peripherals.

For connecting the initiator, the first and second servo outputs are arranged into a separate connector on the back of the flight controller.

An inverter has been added to RX5 to support SBUS (routed to a separate solder pad), which, alongside modern ELRS, allows the use of a wide range of traditional receivers.

All other available UARTs are broken out to solder pads for connecting various sensors or additional control and navigation systems, such as target-acquisition systems. A rich set of UARTs easily connects GPS, VTX, receiver, sensors, and LEDs.

The power stage of the stack is represented by a 4-in-1 electronic speed controller that provides high current, clean power, and fast motor response. ESC: continuous current of 65A, burst up to 80A, operating voltage of 3-6S LiPo/Li-Ion. The regulator is based on 32-bit STM32G071KBU6N controllers with JMSL030SAG power MOSFETs. With active cooling, the regulator withstands a rated current of 65A per channel (peak current of 80A for up to 10s). The telemetry-measured current range is from 0 to 275A. A high current rating (65A) is essential for powerful motors, aggressive flight modes, and heavy-payload FPV drone builds.

The speed controller utilizes the AM32 firmware tailored for 32-bit controllers. Modern AM32 firmware delivers smooth throttle response, high efficiency, fast response times, fine-tuning capabilities, and support for high DShot protocols and modern features. AM32 firmware offers noticeably superior brushless motor control capabilities compared to 8-bit solutions, primarily due to smoother throttle control resulting from higher numerical resolution. This factor significantly impacts flight controller stabilization quality.

The regulator also comes with a high-quality capacitor with pre-soldered 16AWG leads, which properly facilitates current flow and prevents terminal burnout common with standard capacitors.

The somewhat unconventional placement of the motor solder pads in the middle of the board, as close as possible to the MOSFET terminals, is intended to minimize resistance and consequently reduce board heating under heavy loads. Also, while it may seem non-obvious to some, this placement contributes to compact and clean assembly when routing wires through the front and back of the regulator instead of side entry. However, side wire routing is also supported.

Made in Ukraine — providing service and warranty support, reliable communication with the manufacturer, and stable supply chains for the local market.

Features:
  • Thoughtful layout of solder pads
  • High soldering and component quality
  • Reliable component base
  • Proven F405 platform
  • Tested circuit design
  • Updated gyroscope
  • Dedicated BEC for video transmitter
  • Support for up to 6 motors
  • Support for up to 3 servos
  • Dual PinIO interfaces
  • Dedicated connector for initiator connection
  • Reliable ESC operation under load
  • 32-bit controller regulator with low heat generation
  • AM32 firmware - high efficiency, smoothness, instantaneous response
  • Rated current up to 65A per arm
  • High-quality capacitor included
  • Large number of UARTs for GPS, VTX, and other components
  • Vibration and interference resistance
  • Powerful, stable, and reliable
Specifications:
  • Main Controller: STM32F405
  • Application: Multicopters
  • Firmware: Betaflight (ARMADAF405V1)
  • Stabilization: ICM42688P (6DOF 8KHz)
  • Barometer: DPS310
  • Motor Outputs: 6
  • Servo Outputs: 3
  • Total UART Ports: 6
  • PinIO Ports: 2
  • I2C Ports: 1
  • Sbus Inverter: Yes (R5)
  • Peripheral Interfaces: UART; I2C; PWM; PINIO;
  • Receiver Interfaces: PPM; DSM2; DSMX; SBUS; SUMD; SUMH; XBUS; IBUS; JETIEXBUS; CRSF; SRXL; ELRS
  • Protocols: PWM; Oneshot125; Oneshot42; Multishot; Dshot150; Dshot300; Dshot600; DShot1200; Proshot1000;
  • 4-in-1 ESC Output: Present
  • OSD: Built-in AT7456
  • Onboard BEC: 5V/3A
  • VTX BEC: 9-12V/3A
  • RSSI Input: None
  • Satellite Power: None
  • USB Port: USB-C
  • Input Voltage: 11.1-22.2 V
  • Mounting Pattern: 30.5x30.5 mm
  • Mounting Hole Size: 3 mm
  • Dimensions: 54 x 36.5 x 16.5 mm
  • Weight: 10.7 g
  • Type: Brushless ESC
  • Application: Quadcopters
  • Power Supply: 11.1 - 25.2 V
  • Rated Current: 65 A
  • Peak Current: 80 A
  • BEC Presence: None
  • Weatherproofing: None
  • Sensored: None
  • Motor Control Type: PWM
  • Control Protocols: DSHOT1200; DSHOT300; DSHOT600;
  • Cooling: Passive, airflow
  • PWM Frequency: 48 kHz
  • Firmware: AM32 32bit
  • Regulator Build Type: 4-in-1 independent
  • Mounting Pattern: 30.5x30.5 mm
  • Mounting Hole Size: 3 mm
  • Dimensions: 45.5x49.9x6.7 mm
  • Weight: 39.8 g
  • Total Weight: 55.7 g
  • Model Year: 2024
Package Contents:
  • Flight Controller - 1 pc
  • Electronic Speed Controller - 1 pc
  • 35mm Connection Ribbon Cable - 1 pc
  • 50mm Connection Ribbon Cable - 1 pc
  • Dampening Grommets - 8 pcs
  • M3x25mm Mounting Bolts - 4 pcs
  • M3 Nylon Nuts - 4 pcs
  • 12AWG 100mm Power Wires - 2 pcs
  • XT60H-M Power Connector - 1 pc
  • 2200uF 35V Capacitor - 1 pc

Specifications

Technical Specifications

Type
Flight controllers
Application
For quadcopters
Country of Origin
Ukraine
Age Group
Not for children
Material
non-toxic plastic, metal, rubber
Manufacturer Country
Ukraine
Warranty
12 months. Keep the label.
Length
38 mm
Width
38 mm
Height
10 mm
Weight
10 g
EAN
2722945322884

General Information

Model
Flight stack for FPV quadcopter ARMADA F405 V1 65A AM32 3 -6S (set of controller and regulator)
SKU
ARMADA-F405V1-AM3265A
Condition
New (Original factory package)
Warranty
Official manufacturer warranty

Delivery & Payment

Nova Poshta delivery across Ukraine

Dispatch to post branches, parcel lockers, or by courier to your doorstep. All packages are insured for 100% of value. Delivery time: 1–3 business days.

Payment & Pick-up

Flexible options: Cash on delivery at Nova Poshta branch or bank transfer invoice (IBAN) for individuals, FOP and companies.

Shopping Cart

0 items

Your cart is empty

Add items from the catalog to place an order.

Explore Catalog